Masculine Layered Birthday Card | SSS Party like a Panda
top of page
Search
  • Writer's pictureCiara
    • Jun 22, 2020
    • 3 min read

Masculine Layered Birthday Card | SSS Party like a Panda

Updated: Sep 14, 2020


Hello everyone!! Thank you so much for stopping by to check out my Masculine layered Birthday card featuring Simon Says Stamp Party Like a Panda, isn't Monday becoming the best day of the week?? New crafty fun!!! Let's jump right in!!


If you have been with me for a minute you know that I like to have my paper cut down before I start, I used the MFT A2 Sketched Rectangle Dies, for the two largest pieces of cardstock I used the largest and second-largest dies out of the die set, and for the two smaller panels of cardstock I used the third and fourth smallest dies out of the die set.


I then used the Darice Assorted Stars Embossing Folder on the largest white panel for a little added texture and ran it through my die cutting machine after misting the cardstock with a little bit of water. I then took my Mini Misti and stamped out the panda on the smallest panel and the sentiment banner on a scrap piece of paper, using Gina K Amalgam ink, which is a Copic safe ink.


I used my C1, C3 and C5 Copics on the banner to add a bit of shading and to the plate, the panda is holding, for the cake, I used E53 and E21, the icing is BG01 and BG45, the candle is V15 and BG45, and finally the flame on the top of the candle's flame is YR16. I did want to add some texture to the cake so I stippled on some of my darkest colour.


Once everything was coloured I fussy cut out the banner and added some Darice thin adhesive foam strips and placed it under the panda to ground the panda a bit, sadly I didn't end up lining it up perfectly but I don't really mind that. I then used my Gina K connect glue to adhere the smallest layers together. To add some more dimension to my card I used some fun foam behind the smaller black layer and then attached down the last two layers to my A2 sized base.


I added a few Simon Says Stamp Frosted sequins because I just couldn't resist adding a little bling, and I used a little bit of Glossy Accents on top of the candles' flames. If you want to see how I did any of the colouring a bit more in-depth please check out my video below, there is also a fully supplies list below the video.


Thank you so much for stopping by to check out my card and I cannot wait until I see you again!! Look for another video later this week!!




Supplies:


100lb black cardstock


100lb white cardstock (base)


MFT A2 Sketched Rectangle Die


Gemini Go


Neenah Solar White 80lb Cardstock (50 pack)


Neenah Solar White 80lb Cardstock (25 pack)


Simon Says Stamp Party Like a Panda


Simon Says Stamp Woodland Whimsy


Tim Holtz paper trimmer


Darice Assorted Stars Embossing Folder


Studio Katia Triangle Tray


Sequin container:

https://amzn.to/2O5TlEt (Amazon Canada)


Blue Sequins


Copics:


C1


C3


C5


E53


E21


BG01


BG45


YR16


V15


Distress Sprayer


Big shot die-cutting machine


Gink K amalgam ink


Tim Holtz Mini snips


Mini Misti


Gina K connect glue


Crystal Katana


Darice Adhesive Foam strips


Glossy Accents


White Fun Foam

Affiliate links are used whenever possible, and when you use those links I get a small commission at no extra cost to you. Thank you for your support!


8 views0 comments
bottom of page